Suitable for a working pressure up to 40 bar
Pressure peaks can be absorbed with a sufficient margin of safety
Filter elements as fine as 5 μm(c) are available; finer filter elements on request
Suitable for all petroleum based fluids, HW-emulsions, most synthetic hydraulic fluids and lubrication oils
High intrinsic stability
Excellent filtration capabilities
High dirt retaining capacity
Long service life

Type		Trykkfilter, Change-over According to ASME-code
Temperature range		-10°C to +80°C
Operating medium		Mineral oil, other media on request
Max. operating pressure		40 bar
Test pressure		52...60 bar
Connection		SAE-flange 3000 PSI
Housing material		Steel
Sealing material		Nitrile (NBR) or Viton (FPM), other materials on request
Installation position		Vertical
Bleeder connection		NPT ½“ and SAE ¾“ 3000 PSI
Drain connection dirt side		NPT ½“ and SAE ¾“ 3000 PSI
Drain connection clean side		NPT ½“
Volume tank		2 x 19 l
Classification		Pressure Equipment Directive 97/23/EC for mineral oil (fluid group 2), Article 3, Para. 3 ATEX Directive 94/9/EC according to specific application
For mer informasjon		Datablad --- Oversikt --- Brosjyre

		Internormen DA 1004 trykkfilter - Change-over - ASME-code				Internormen DA 1005 trykkfilter - Change-over - ASME-code

		Internormen DA 1015 trykkfilter - Change-over - ASME-code				Internormen DA 2204 trykkfilter - Change-over - ASME-code

		Internormen DA 2205 trykkfilter - Change-over - ASME-code				Internormen DA 2214 trykkfilter - Change-over - ASME-code

		Internormen DA 2215 trykkfilter - Change-over - ASME-code				Internormen DNA 250-630 trykkfilter - Change-over - ASME-code

		Internormen DNA 1050-2050 trykkfilter - Change-over - ASME-code				Oversikt Internormen trykkfilter - Change-over - ASME-code