PEES Components AN402 Servo amplifier

PEES Components styringsenheter
  • The AN402 servo amplifier module is intended for the control of single magnet proportional valves
  • The control algorithm, ramps and similar command variables are derived exclusively from an external computer (PLC)
  • Snap-on housing enables mounting on normal carrier rails in control cabinets
  • Electrical connections via a terminal strip and a flat connector (enable input)
  • Duplex output stage with high-dynamic response and rapid deexcitation
  • Rapid switch-off of the magnet coil (approx. 4...6 ms)
  • Multi-turn resistances allow the adjustment of volumetric flow amplification, pressure amplification and Imin jump
  • Integrated ramp generator that allows adjustment of the ramp times (ramp up, ramp down) by means of two multi-turn resistances
  • The ramp can be switched off externally by an input (ramp off)
    
Kontakt Hydex vedrørende PEES Components AN402 Servo amplifier

Type    Servo amplifier
Use Control of single magnet proportional valves
Supply voltage 24V DC (22...32 V DC)
Temperature range 0...+50°C
Output stage Duplex output stage with high dynamic response and rapid deexcitation (approx. 4...6 ms)
PWM frequency Approx. 5kHz
Dither Approx .150 Hz factory setting Amplitude adjustable on the 'Dither' potentiometer within a range of approx. 0 - 10% of the nominal current setting
Input 0...10V (differential input)
4...20mA (differential input)
Measuring sockets Current: valve current: 1V/A (10%)
Command: setpoint signal (0...10V)
For mer informasjon Klikk her --- Datablad

Kontakt Hydex vedrørende PEES Components AN402 Servo amplifier


 
Page rendered: 28.12.2022 22:00:40
OXX.Authorization.User.Username: Hydex_Systemhydraulikk_anonym (NO)