The ADN 411 has been developed as a CNC control system for operation with a valve in which the electronics are mounted on the valve
The assembly consists of two modules, MD6 is the basic module (equivalent to ADN 407), and MD14 is the add-on CNC module
Equipped with an SSI interface for operation with an absolute position encoder, such as absolute shaft encoders or Temposonic, for example
An interface which permits incremental position measurement is also included
A total of 11 inputs and 5 outputs
Equipped with two microprocessors, each of 40MIPS
Equipped with the CAN bus
All settings are effected using the ADN configurator via an RS232 interface in combination with a PC or laptop computer

Type		CNC control system
Use		Operation with a valve in which the electronics are mounted on the valve
Supply voltage		24V DC, nominal (22...28V) DC
Inputs		11, opto-decoupled of which 1 x Enable
Outputs		5 x 24V/100mA
Measuring sockets		The output signal can be measured at +/–10V for maximum level on Measuring Sockets M1 and M2
Temperature range		-20°C...+60°C
Controller setting range		1 to 32000 for P, I, DT1
Sensor modules for MD1		±10V, 12mA ±8mA, 4–20mA, 0–10V, 7.5V ±4V
For mer informasjon		Klikk her --- Datablad