The ADN 410 has been developed as a CNC control system for operation with a servo-valve
The assembly consists of two modules, MD3 is the basic module (equivalent to the ADN 404), and MD14 is the add-on CNC module
Equipped with an SSI interface for operation with an absolute position encoder, such as absolute shaft encoders or Temposonic, for example
An interface which permits incremental position measurement has also been included
Equipped with two microprocessors, each of 40MIPS
A total of 11 inputs and 5 outputs
Profibus DP is available
All settings are effected using the ADN configurator via an RS232 interface linked to a PC or laptop computer

Type		CNC control system
Use		Operation with a servo-valve
Supply voltage		24V DC, nominal (22...28V) DC
Inputs		11, opto-decoupled
Outputs		5 x 24V/100mA
Measuring sockets		The valve current can be measured at +/–20mA = +/–10V, +/–50mA = +/–10V, etc., on Measuring Socket M1. Sensor 1 can be measured on M2.
Temperature range		-20°C...+60°C
Controller setting range		1 to 32000 for P, I, DT1
Sensor modules for MD3		±10V, 12mA ±8mA, 4–20mA, 0–10V, 7.5V ±4V
For mer informasjon		Klikk her --- Datablad