PEES Components AN410 pressure controller

PEES Components styringsenheter
  • The AN410 pressure controller module is intended for pressure closed-loop-controls in conjunction with a pressure control valve
  • When the controller enable is switched off, the unit operates as an open loop controller in which the system pressure is adjusted in the usual manner by the valve current in conjunction with the control characteristic
  • When the controller is enabled, the well-known disadvantages of open loop control are compensated and the pressure is controlled free of hysteresis, irrespective of the temperature and linear to the setpoint
  • The actual pressure value is monitored for wire break and is available as a 0...10V signal on terminal 12 for measurement purposes
  • Adaptation to the control system is possible using the P and I potentiometers
  • Snap-on housing enables the AN410 module to be mounted on normal carrier rails in control cabinets.
  • Electrical connections are done by a terminal strip and 3 flat connectors
      
Kontakt Hydex vedrørende PEES Components AN410 pressure controller

Type Pressure controller
Use Pressure closed-loop-control in conjunction with a pressure control valve
Supply voltage 24V DC (22...32 V DC)
Temperature range 0...+50°C
Output stage Duplex output stage with high dynamic response and rapid deexcitation (approx. 4...6 ms)
PWM frequency Approx. 5kHz
Input (various input modules are available) Setpoint:
- 0...10V (differential input) 
- 4...20mA (monitored diff. input)
- 0...20mA (differential input)
Actual value:
- 4...20mA (monitored diff. input)
Measuring sockets Current: valve current: 1V/A (10%)
Command: setpoint signal (0...10V)
M1: controller output
For mer informasjon Klikk her  --- Datablad

Kontakt Hydex vedrørende PEES Components AN410 pressure controller


 
Page rendered: 28.12.2022 22:00:41
OXX.Authorization.User.Username: Hydex_Systemhydraulikk_anonym (NO)